Momentary Neopixel Switch

Nuevo

Neopixel Switch

Presolder MicroJST connector

3,7V

Más detalles

3 Artículos

Advertencia: ¡Últimas unidades en stock!

9,95 €

Más información

Iluminated momentary switch.

Soundboard Compatible Same or above: Spark3, Spark3Color, Igniter 3, Nano Biscotte V4/ Primz V5, ProffieBoard, Teensy saber (all versions)

Not compatible: Spark2, Spark2Color, Igniter2, Nanobiscotte v3/Primz 4

Color: Neopixel RGB

Resistor: Need a 330-470ohm resistor in Data Line (yellow wire)

Presolder MicroJST Female+Male, you not need extra connector

Hole diameter 12mm

Outside Circle diameter 14mm

Saberforge compatible.

Pinout:

Black: GND

Red: Vin 3,7V

Green: Button

Yellow: Data Line, you must add  330-470ohm resistor.

ADITIONAL INFO:

Proffie Board/Teensy Saber: Config the switch as a new blade with this code:

 WS2811BladePtr<1, WS2811_580kHz | WS2811_RGB, blade2Pin, PowerPINS<> >(),

Other boards:

Solder Data Line to main blade Neopixel Data line in the Soundboard. So the switch will mimic the Main Blade.

Reseñas

Escriba una reseña

Momentary Neopixel Switch

Momentary Neopixel Switch

Neopixel Switch

Presolder MicroJST connector

3,7V

Accesorios